free SHIPPING on Most Sizes in the Continental USA
qUESTIONS? cALL 866-778-0460

EAP How To Install Your New Shutters

How To InstallTo install the shutters - follow the five steps listed below:

Step 1 - Place the shutter next to the window and mark desired location against the wall or window.

Step 2 - For smaller sizes use four Shutter-Loks per shutter. For large sizes 55" and over, use six Shutter-Loks per shutter.

Step 3 - To help ensure proper alignment mark or pre-drill holes using a 1/4" drill bit into the shutter before attaching it to the wall.

Step 4 - With the shutter in location against the wall, drill through the shutter into the wall surface 3 1/4" deep. Make sure you drill holes deep enough so the Shutter-Lok doesn't bottom out.

Step 5 - Grasp the Shutter-Lok supporting shank and push it through the shutter hole and into the wall surface. Tap the Shutter-Lok gently with a hammer to snug the shutter against the siding. Do not over tighten , or this will cause the shutter to dimple.

Note: To remove shutters do not attempt to pull out the Shutter-Loks. Simply use a pair of snips and slide them behind the shutter to cut the Shutter-Lok off at the shank. Additional Shutter-Loks can be purchased separately.